Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About rabih_saleh
Stats
Member since
03-14-2007
18
Posts
0
Helpful
0
Solutions
12-30-2015
11:45 AM
i have this license
Nexus-7004# show license license_JPG1924006V_108.lic: SERVER this_host ANY VENDOR cisco INCREMENT LAN_ENTERPRISE_SERVICES_PKG cisco 1.0 permanent uncounted \ VENDOR_STRING=MDS HOSTID=VDH=JPG1924006V \ NOTICE=<LicFileID>20151103142536000</LicFileID><LicLineID>1</LicLineID>< PAK>N7K-C7004JPG1924006V</PAK> \ SIGN=0BA2D0E0BFDC
... View more
12-30-2015
11:39 AM
Hello Reza,
Yes already have Enterprise license , and the feature of PBR is enabled .
Thanks,
... View more
12-30-2015
11:30 AM
Hello, I'm doing a Policy based routing on nexus 7004 but some how it is not working properly with me but it was working fine on nexus 5000 ! the concept of this i have two internet connection and i need to allow some users to use ADSL connection and another users to use the a leased line connection , the below is commands; ip access-list ADSL permit ip 192.168.3.43/32 any ip access-list ADSL_ALLOW_INSIDE permit ip 192.168.3.43/32 10.178.0.0/16 permit ip 192.168.3.43/32 172.25.0.0/16 permit ip 192.168.3.43/32 172.168.5.0/24 route-map ADSL deny 9 match ip address ADSL_ALLOW_INSIDE route-map ADSL permit 10 match ip address ADSL set ip next-hop 192.168.252.1 interface vlan1 ip policy route-map ADSL
... View more
Labels:
12-03-2012
02:59 AM
Hello, I would like to do VPN site to site using ASA 5520 and i have a few question if you don't mind : Site A: Peer IP address: aaa.aaa.aaa.aaa/32 Local Network: bbb.bbb.bbb.bbb/32 Site B: Peer IP Address: xxx.xxx.xxx.xxx/32 Local network: yyy.yyy.yyy.yyy/32 on the wizard site to site vpn (site B) the peer network should be the site A and the local network should be the site B and remote network should be the site A right ? the local network IP address should be not be used right by another devices right ? i can use use a single IP address instead of network range on local and remote network ? since the customer on site A provide me a single IP address ? can i allow on site A to browse only a single IP address on my site B and allowing only ports 80 and 443, please can you provide me example i prefer ASDM . Thanks and waiting for your help.
... View more
Labels:
09-14-2012
11:56 AM
hi, so i can't use RPS 600 right ? even if i purchased cable 22-14 pin right ?
... View more
09-14-2012
02:15 AM
Hi, I have CISCO RPS 600 (PWR-AC-RPS) is it support Catalyst 2960 and 3560 ? and which type of cable require since i have cable 22-18 pin and on my switch require 22-14 pin, please can i know the cable model ? Thanks,
... View more
- Tags:
- rps
Labels:
06-05-2012
11:08 AM
Hi Nik, Thanks for your support, please can you help me on parameteres as i already added the command: logging rate-limit all 5000 but still i'm getting this error: access-list logging rate-limited or missed XXXX packets Thanks, Rabih
... View more
06-04-2012
10:52 PM
Hi, I'm looking for help as I'm getting this error message on syslog server (Kiwi syslog) access-list logging rate-limited or missed XXXX packets i did the following commands but still I'm getting the error : logging buffered 16386 debugging logging rate-limit all 5000 no logging console no logging monitor ip access-list logging interval 30000 ip access-list log-update threshold 30000 i don't want to report to the console or monitor i want to report direct to syslog server, because I'm monitoring all the traffic ( permit ip any any log ) ! Thanks for your help, Rabih
... View more
Labels:
03-22-2011
08:29 AM
Hi, I have a CISCO ASA 5520 with ASA version 7.0(8) and ASDM version 5.0(8) I need to upgrade it to new image, I’m confusing which version I have to select since my requirement only to view the IPv6 on ASDM. The existing ASDM doesn't show the IPv6; please can you help me on which version I have to select for ASA image and ASDM? And I don't think I have to select the latest version! Thanks, Rabih
... View more
Labels:
01-30-2011
04:56 AM
I have a CISCO ASA 5520 with ASA version 7.0(8) and ASDM version 5.0(8) I need to upgrade this to ASA Version 8 and ASDM Version 6. I know I am not supposed to upgrade directly to those versions. But do I have to upgrade to each available upgrade first before getting to versions 8 and 6 respectively? Thanks, Rabih
... View more
Labels:
09-24-2010
12:34 AM
hi, i need help on ASA 5520 and i would like to block countries IP address from the attack, there is any way to block countries ip address or range ip address . Thanks, Rabih
... View more
Labels:
07-25-2010
11:00 AM
Dear Mr. Nagaraja, waaawwwwwww many many many many thanks , really you are professional my problem solved . Thanks and many thanks for you. My best regards, Rabih
... View more
07-25-2010
07:01 AM
i change the ip's and working fine OLD IPS: Vlan 177 : 100.1.0.177 to 100.1.0.190 255.255.255.240 Vlan 193 : 100.1.0.193 to 100.1.0.206 255.255.255.240 i changed the ips to : NEW IPS: Vlan 177 : 10.162.177.254 255.255.255.0 Vlan 193 : 10.162.193.254 255.255.255.0 and without any route. All devices and pcs working fine without gateway. My Question is: when i'm using the old ip's is not working fine i can't ping the devices which doesn't have gateway, but my problem i have to use the old ip's. Please help.
... View more
07-25-2010
01:26 AM
hi, i can ping group B from Group A and from Group A i can ping Group B Group A [pc have this ip] ip 100.1.0.177 255.255.255.240 gateway 100.1.0.190 Group B [pc have this ip] ip 100.1.0.193 255.255.255.240 gateway 100.1.0.206 but if i remove the gateway from pc on group A i can't ping the pc on group B, why i'm testing like this because i have devices doesn't have gateway. Thanks for your help my configuration now is : show run Building configuration... Current configuration : 3887 bytes ! version 12.2 no service pad service timestamps debug uptime service timestamps log uptime no service password-encryption ! hostname CiscoL3 ! enable secret 5 ************ enable password *********** ! username ****** privilege 15 secret 5 ************* no aaa new-model system mtu routing 1500 ip subnet-zero ip routing ! ! ! ! --More-- no file verify auto spanning-tree mode pvst spanning-tree extend system-id ! vlan internal allocation policy ascending ! interface GigabitEthernet0/1 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/2 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/3 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/4 switchport access vlan 177 --More-- switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/5 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/6 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/7 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/8 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! --More-- interface GigabitEthernet0/9 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/10 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/11 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/12 switchport access vlan 177 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/13 switchport access vlan 193 switchport mode access --More-- spanning-tree portfast trunk ! interface GigabitEthernet0/14 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/15 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/16 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/17 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/18 --More-- switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/19 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/20 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/21 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/22 switchport access vlan 193 switchport mode access spanning-tree portfast trunk --More-- ! interface GigabitEthernet0/23 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/24 switchport access vlan 193 switchport mode access spanning-tree portfast trunk ! interface GigabitEthernet0/25 spanning-tree portfast trunk ! interface GigabitEthernet0/26 spanning-tree portfast trunk ! interface GigabitEthernet0/27 spanning-tree portfast trunk ! interface GigabitEthernet0/28 spanning-tree portfast trunk ! --More-- interface Vlan1 no ip address ! interface Vlan177 ip address 100.1.0.190 255.255.255.240 ! interface Vlan193 ip address 100.1.0.206 255.255.255.240 ! ip classless ip route 100.1.0.192 255.255.255.240 100.1.0.176 ip http server ! ! control-plane ! ! line con 0 exec-timeout 0 0 password ************** login line vty 0 4 password ***************** --More-- login line vty 5 15 password ************ login ! end
... View more
07-24-2010
09:34 PM
Many thanks for your support. i have 2 departments each department on different subnet, the department A have ip range from 100.1.0.193 to 100.1.0.206 255.255.255.240 and the second department have ip range from 100.1.0.177 to 100.1.0.190 255.255.255.240 just i want to do vlan and route between 2 departments and i don't want to put gateway in the pc's [if possible] because i have devices doesn't have facility to put gateway ip address. please your help. Thanks
... View more
12-30-2015
i have this license Nexus-7004# show
licenselicense_JPG1924006V_108.lic:SERVER this_host ANYVENDOR
c...
12-30-2015
Hello Reza, Yes already have Enterprise license , and the feature of PBR
is enabled . Thanks,
12-30-2015
Hello, I'm doing a Policy based routing on nexus 7004 but some how it is
not working properly with m...
12-03-2012
Hello,I would like to do VPN site to site using ASA 5520 and i have a
few question if you don't mind...
09-14-2012
Hi,I have CISCO RPS 600 (PWR-AC-RPS) is it support Catalyst 2960 and
3560 ? and which type of cable ...
Created by
rabih_saleh
in Switching
06-05-2012
06-05-2012
Hi Nik,Thanks for your support, please can you help me on parameteres as
i already added the command...
Created by
rabih_saleh
in Switching
06-04-2012
06-04-2012
Hi,I'm looking for help as I'm getting this error message on syslog
server (Kiwi syslog)access-list ...
03-22-2011
Hi, /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table
Normal"; mso-tstyle-rowband-...
01-30-2011
I have a CISCO ASA 5520 with ASA version 7.0(8) and ASDM version 5.0(8)
I need to upgrade this to AS...
09-24-2010
hi,i need help on ASA 5520 and i would like to block countries IP
address from the attack, there is ...
07-25-2010
Dear Mr. Nagaraja,waaawwwwwww many many many many thanks , really you
are professional my problem so...
07-25-2010
i change the ip's and working fineOLD IPS:Vlan 177 : 100.1.0.177 to
100.1.0.190 255.255.255.240Vlan ...
07-25-2010
hi,i can ping group B from Group A and from Group A i can ping Group
BGroup A [pc have this ip]ip 10...
Public Statistics
| Date Registered | 03-14-2007 12:56 AM |
| Date Last Visited | 08-18-2017 03:56 AM |
| Total Messages Posted | 18 |
