About Steven Palfreyman

Steven Palfreyman · 04-30-2012

Hello,I'm trying to figure out how to check compliance for only one access list in cisco works.Example:I want to run a compliance template that only check access-list 13 to make sure it has the following and nothing else:access-list 13 permit 1.1.1.1...

Steven Palfreyman · 04-04-2012

Hello,In Cisco WCS (7.0.230.0), does anyone know if there is any way to show what SSIDs an LWAPP is broadcasting? I can see the SSIDs assigned to the group that the AP is a part of through the controller or templates, but is there an easy way to see ...

Steven Palfreyman · 04-04-2012

Hello,I'm new to the realm of wireless and I'm at a loss of how to resolve this. In WCS when I look at buildings on the map, it shows the status as critical with a red triangle, but when you click on the building all access points are green and okay...

Steven Palfreyman · 05-01-2012

New discovery for me, but already noted in the forums to some extent when talking about ordered lists.If you have ip sla enable reaction-alerts on your device, the Compliance check comes back like this (shows all ACLs):-ip sla enable reaction-alerts ...

Steven Palfreyman · 05-01-2012

I think right now, I'm going to have to do this in two stages:1. Use Compliance Mgmt to check if the access list 13 exists and what else is there.2. If the access list 13 exists, use NetConfig to deploy the new access list 13.Thank you for all of you...

Steven Palfreyman · 05-01-2012

Thank you for your response; I appreciate it.So I did some more research and I have a Condition Block set to check if there is an access-list 13 on the device and proceed if there is: + [#access-list 13.*#]Then, in the compliance Block I'm checking t...

Steven Palfreyman · 04-06-2012

Steve,Again, thank you for your response. I will put more trust into WCS and the controllers as I continue to grow and learn about them.Thank you,Steve

Steven Palfreyman · 04-05-2012

Steve,Thank you for your reply on this matter. What I'm hoping to find is a way after you assign an AP group name to an access point, so it knows what SSIDs to broadcast, is there a way while looking at the map of APs in WCS for a floor to show that...

Member Since	‎02-22-2012 04:20 PM
Date Last Visited	‎12-16-2019 05:29 PM
Posts	9

User Statistics

User Activity

LMS 3.2 Checking compliance for a single access list

WCS in monitor maps, any way to see SSID that AP is broadcasting

WCS building shows status as critical, but APs are green.

LMS 3.2 Checking compliance for a single access list

Re: LMS 3.2 Checking compliance for a single access list

Re: LMS 3.2 Checking compliance for a single access list

Re: WCS in monitor maps, any way to see SSID that AP is broadcas

Re: WCS in monitor maps, any way to see SSID that AP is broadcas