Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone explain these different operating temperature ranges? I would think it doesn't matter the enclosure that the switch is in, it will either work or fail at a certain temperature.• -40C to +70C (Vented Enclosure Operating)• -20C to +60C (Seal...
Any one know how to configure a password policy on the local username account (ex. 8 characters, with numeric char. in it, etc.)?? I know the above question has already been presented several years ago, but I'm wondering if anyone has any additional...
When IPSEC traffic is de-crypted on a cisco 877 Dialer interface, what is the next step? If the Dialer interface is a member of the 'outside-zone' (ZBF) and the packet SA is 10.1.1.1 and the DA is 10.2.1.1 (which is part of the 'inside-zone'), does t...
When we upgrade our 7204vxr processor card to NPE-G2, how will those ports show up in the running configuration? Will our current ports/interfaces change?
Thanks for the responses. I guess I should have mentioned in the original post that we do use TACACS but this actually for an audit. A government regulatory committee wants documentation on the device itself.Thanks again.
Mike,I do have what you mentioned in place already, I just didn't think this order of operation was correct. So I basically can't block ALL RFC 1918 on my DSL interface if I have a site-to-site tunnel using a private network?Thanks for the response.
Ganesh.H,I guess I left out some information. We are currently using the inbound load balancing with the LinkProof, BUT there are some other features with the LP that don't work. So we are migrating to just using routers/l3 switches in our internet s...
