Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So, i am trying just to do the initial setup of a Cisco PIX515e 6.3, and I am hitting a brick wall. I got the console up, thought that I had everything configured correctly (Like internal IP and such), but I can't ping to or from, with a crossover...
Ok, so this is weird. I have a new 6509e that is set for trunking to an older WS-C3560G-24TS-S. Version for the WS-C6509-E is s72033-advipservicesk9_wan-mz.122-33.SXI7Version for the WS-C3560G-24TS-S is c3560-ipbase-mz.122-25.SEE3Both ports are set f...
So, I made the fatal mistake while consoled in to do a "Show Run". Now, it is just stuck in that cycle. I tried the usual "Ctrl+Shift+6" command, and even the "Ctrl+6" with no success. Any help would be great. Thanks
Just as the title states. I have a current ASA running as my VPN point. I want to copy just the VPN setting from this ASA, and push it to another, without changing the main setting/config. Current Version on the ASA 5520Current ASDM version as well. ...
Running an ASA 5500, and using ASDM to connect. I need to view the historical metrics in graph form for traffic overview, that is shown on the firewall dashboard. I have enabled historical data, but all I see the 5 minute intervals. Thanks
I am unsure about that. I will have to check that out and get back tomorrow. Will that cause an issue? Thought for the longest time now that Cisco Ports are Auto sensing, and while good practice, it is not needed anymore.
