Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Based on the Cisco documentation I added these lines into the config of the switch:policy-map jumbo class class-default mtu 9216system qos service-policy jumboWhen I run a show int though I'm still seeing the MTU set as 1500. Any ideas? Is the...
I tried to FTP a new version of firmware to my 11501 last week. For some reason it got stuck at about the 3MB mark and just keeps sitting there churning like it's still trying to grab it. I've killed the FTP process on my desktop and rebooted the C...
Right now it's 4.0(1a)N1(1) but I'm getting ready to upgrade to the newest code. I also opened a case with the TAC; they sent me a link to documentation with a different (slightly) set of commandsThanks for the reply.
OK... I've gone and created the vlans as interfaces instead and assigned them the ip addresses, etc.The problem now is that when i go onto the interface that is going to be the trunk and try usingswitchport mode trunkI get an error:command rejected:...
I'm assuming you're going to have multiple vlans going over that port-channel. I'm having a similar issue.I create the port-channel and then the sub-interface. Then when I try using the command: encapsulation dot1Q 161I get an error:Command rejecte...
