Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have one C220 connects to Nexus 5548UP via FCoE, but the vfc is in trunking, and the vsan is waiting for flogi.Below is the conf,vlan 1000 fcoe vsan 1000 vsan database vsan 1000 interface vfc1 bind interface Ethernet1/1 switchport trunk allowed...
We find the issue is the battery of the RAID controller.Sometime we will get following messages on screen:USB cache device is not responding.From the linkhttp://www.cisco.com/en/US/docs/unified_computing/ucs/release/notes/OL-28995-01.htmlWe find foll...
Hello Herve,We found the RAID controller is failed. When we pressed F2 or F6, it just displayed Entering setup or Entering boot menu..., until we removed RAID controller.Then we update the firmwares on C220, we can configure LUN and we can install ...
Hi Yakov,Did you solve the same problem when I try to SAN boot a C220 which is directly connect to the 5548UP.thanks,JeffSent from Cisco Technical Support iPhone App
same.show int vfc 1vfc1 is trunking Bound interface is Ethernet1/1 Hardware is Ethernet Port WWN is 20:00:00:2a:6a:0a:66:ff Admin port mode is F, trunk mode is on snmp link state traps are enabled Port mode is TF Port vsan is 10...
