Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can't add my CT8540 8.1.102 to my PI 2.2.2, I use snmp V3
I add a SNMP V3 user to my CT8540 ( user, authen Proto HMAC-SHA and Privac Proto CFB-AES-128).
I add the devise to my PI , I use snmp V3 and SSH , when I check credential I have only this m...
When i performe the sync I check only yhe ISE who had the warning and i click syncup.
In your prevous reply you ask to check all ISE (Then select/check all of the nodes and click on the "Syncup" button above the personas.)
When i performe the sync I check only yhe ISE who had the warning and i click syncup.
In your prevous reply you ask to check all ISE (Then select/check all of the nodes and click on the "Syncup" button above the personas.)
Hi,
I have two nodes,
the 1 st one is OK ==> Pri (A) and Sec (M),
the Second is not sync ==> Sec (A) and Pri (M).
when I want to sync it i have this message :
Error : unable to load/admin/syncup Action.do?command=syncup DB status:12002
my problem...
Hi Rasika,
I upgrade my CT8540 to version AIR-CT8540-K9-8-1-131-0 but we have the same issue with PI2.2.2, PI2.2.3 and we try also today with PI 3.0.
Can you tell me in witch version are your CT8540 ?
