Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our main office is connected to a very small branch office via a T-1 line. Connected to the T-1 is a C2821 at each site.There is an ASA5520 at the main office, and an ASA5510 at the branch office. Traffic between the sites uses a Site-to Site VPN t...
My ASA is 7.2(2) & ASDM is 5.2(2).I will be upgrading the IPS module from v5.0.2 to v6.1.1.What version of ASA/ASDM do I need to fully support IPS 6.1 ?
This 1841 router has a WAN Interface(WIC-1DSU-T1-V2), two embedded Fast Ethernet Interfaces, and a Four-port 10/100 Ethernet switch interface card.My question is in regards to the 4-port switch. Is it in its own subnet, separate from the embedded po...
The Standby ASA5520 started logging the following message sequence for each interface:(1)%ASA-1-105005: (Primary) Lost Failover communications with mate on interface ________(2)%ASA-1-105008: (Primary) Testing Interface ________(3)%ASA-1-105009: (Pri...
Great. I haven't been able to get it to work yet. I think I need to make another entry in the cryptomap access list for the ASA outside interface. Haven't tried it yet.
Should the devices connected to the 4ESW 4-port switch be configured for a subnet that is different than the embedded Ethernet ports?How would I give an IP address to the 4ESW for management purposes?
