Hi,We are using 8510 MCU ( 4.3/1.68) registered to VCS (7.0.3). We use TMS 13.2 to schedule calls on the 8510 MCU. Issue is that on two occasion, TMS interconnected 2 VCs with one another. All particpants connected one the first VC, also connected on...
Hi,We have 3 VCS Control devices that have been neighboured to each other. Each VCS also has a SIP trunk to Cisco Call Manager. Is there a way to check the utlization of this SIP trunk and also the utlisation of each of the neighbour zones created on...
Incorrect connection status being displayed - A resource shows as connected on TMS but in reality is not and vice versa. Moreover there are considerable delays in getting a site connected. Sometimes it does not connect. This is is same for both m...
- Both the conf was setup as Dial-Out from the MCU. However there were some dial-in participants as well in the 2nd Conf- Both the conf were on the same MCU. the 8510 MCU is a cluster of 3 8510 MCUs which are in an MSE8000 chassis. Calls are always c...
- Setup is simple. We have a cluster of 2 VCS. 8510 MCU and Video Endpoints register to the same VCS cluster. They are registered to the master VCS in the cluster- TMS is used for call scheduling- Each conference scheduled via TMS, gets registered to...
