Hello,We have a problem with stacked 2x 3750-X's ethernet links bundled to port channel to 2960-X access switches (there are multiple of 2960-X's).The setup is as follows:Cat3750-X_1 GE 1/0/3 <--------> Cat2960-X GE 1/0/47Cat3750-X_2 GE 2/0/3 <------...
Hello,I have a problem with a lot of output drops on one of the fastethernet interfaces (router is Cisco 3745)FastEthernet0/1 is up, line protocol is up Hardware is Gt96k FE, address is 000d.bc09.cba1 (bia 000d.bc09.cba1) Description: TRUNK MTU 1...
Hello everyone,problem was traced to a number of small hubs used to "extend the network" without our knowledge :).Thanks to everyone involved in problem solving for providing tips and giving ideas.sorry for not replying sooner, been really busy.Best ...
Hello Aninda,I've just noticed this in the log of one access switch:Dec 2 07:14:19.212 CET: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/27, changed state to downDec 2 07:14:20.211 CET: %LINK-3-UPDOWN: Interface GigabitEtherne...
Hello everyone,thank you for taking interest in my problem. @Peter1. Yes it does happen with all the 2960-X's (3 of them). here is the log from this morning (note that last log from last night was me configuring the switch):Dec 1 22:17:56.599 CET: %...
Great find, thanks for updating the thread Jeremy!Now that I think about it we also had mismatch between UCS and Nexus qos weights, guess that could have been the problem. We went with the native FC uplinks but this is good to know!Adi
Hi Jeremy,TAC said that we need to turn on the FCoE Uplinks to do troubleshooting but we were unable to since this is now a production enviroment :\. They also suggested that Cisco HBA driver on the Win2012 server is a bit out of date and we should t...
