Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two sites connected with L2L tunnel using Cisco PIX firewall as below --- Site A : Local subnet 172.16.0.0/16Site B : Local subnet 172.16.0.0/16, 192.168.11.0/24, 192.168.12.0, 192.168.13.0 To establish reacahbility of 1 duplicate subnet on bo...
Dear Friends,I have Cisco PIX 525 running in my network with inside network pool 172.16.0.0/16. I already have 2 Site to Site VPN tunnel running on same firewall with 2 remote locations with other than 172.0.0.0/16 subnets in 2 remote locations.Now I...
Dear All,I have Cisco ASA 5520 running in my setup and want to execute "clear xlate" command at every 1 hr interval. Can anybody help me to automate the same like cronjob in linux.Thanks in advance for your kind support.
Dear Friends,I have WS-3750G-12S-E with me and would like to configure BGP on the same. I want your suggestion / help whether it is advisable to configure BGP on 3750G or not.Please suggest if anybody has already deployed BGP on 3750.Thanks in advanc...
Thanks Jan for your input. But please note that only one subnet is duplicate (after NAT it is reachable) and other 3 subnets are unique in both sides. So I hope NAT for those subnets are not required.One more input here is the firewall @ Site B is di...
Yes. frederic. But i observed that after running "clear xlate" command problem is getting resolved.Please let me know information you require to troubleshoot further as I am expecting this issue to come in 2-3 hours.Now everything running fine.
Thanks Frederic for your reply.I have gone through Call Home setup commands but not able to get exact steps to follow "clear xlate" command as most of the examples of Call Home is to send traps or alert of some specific output.Can you please provide ...
