Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I've got random connection issue when I try to connect to a VPN gateway through an ASA 5510 (IPSEC client ->ASA 5510->VPN Gateway).When the tunnel is coming up, those two lines appears in the captured traffic on the internal interface :<private in...
Hi,I've got a problem with a 2960 : average cpu utilization of 50%. I can see the 50% load with this command : sh process cpu history but when I enter sh process CPU sort (5sec, 1min or 5min). I cannot see which process is loading the CPU. I don't un...
Hello,I set a vlan trunk between 2 switches. the first switch is a 3750 and the second one a 2960 (24TS-S). I don't use VTP, I enter this command on the 2960 for the trunk port : switchport mode trunk. The VLAN propogation works fine but the switch a...
Hello,I have two physical network (10.100.0.0/16) and (11.0.0.0/8). A Cisco router route the traffic between these networks.I have a problem on one switch (catalyst 2950) located on the 11.0.0.0/8 networkFrom this switch, I can ping the machine 10.10...
Same problem here !I'm happy I've found people with the same problem since I've already post regarding this issue :At first, I thought I had a problem with my trunking settings (I'm not a Cisco expert) : https://supportforums.cisco.com/thread/2025472...
Guiseppe,Yes this is an interrupt problem, but if I add up the process percentage, I'm far from 50%This the result of sh process cpu sort :CPU utilization for five seconds: 7%/1%; one minute: 42%; five minutes: 49% PID Runtime(ms) Invoked uSec...
