Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
are PVST+ and Rapid PVST+ compatible, do they interoperate ?with root bridges running PVST+ and new distribution switches running Rapid PVST+ - will this setup work ?
what's the usual behavior of the switch interface when it's "flowcontrol receive on" is enabled on the interface, Does it buffer the packets for duration of time mentioned in the flowcontrol message or does it drop the packets or is it a combination ...
this might sound like a dumb question R1 (1500) <-> (1400) R2 (1400)<->(1500) R3with the above setup if R3 sends a ping packet to R1 with a packet size of 1500 and df-bit set, Will it be dropped by R2 at the ingress interface or at the egress interfa...
Hi Ali, The only change is that your interesting traffic ACL would have the ip address assigned to your Management Interface , rest of the configuration will remain the same.I replied to my inbox last week only for the mail to bounce back HTHVikra...
so for Destination static nat to work should i create both these object-groups or will Object network SERVER-IP-172.16.1.100 do ?Object network SERVER-IP-172.16.1.100host 172.16.1.100nat (outside,inside) static 10.1.1.100Create object for inside IP ...
Hi Soroush, When should I use src-dst-ip loadbalancing, is this dependent on the IOS version ? I am trying to figure out how the switch falls back to src-dst-mac loadbalancing when src-dst-ip loadbalancing is configured on it .As an example i am r...
