About harryfolloder

harryfolloder · 12-17-2012

I am having the telco (AT&T) forward a legacy # to the new main number. Calling the new main nummber, the call works perfectly. When calling the old main # that is forwarding at the carrier level, it will not match and send to unity.The call flow is ...

harryfolloder · 12-18-2012

Thanks for the tip on the port monitoring tool. I always forgot Unity utilizes ther RTMT in addition to CUCM. I utilize it all the time with CUCM but always forget that Unity works in it too.So, you were correct and I actually had it setup correct t...

harryfolloder · 12-17-2012

Your comment is correct, the called number is the leacy number. The called number is not ported over to our SIP trunk yet so I have to relay upon AT&T to forward the number on their side rather the use a translation pattern and a mask on CUCM.Called...

harryfolloder · 04-23-2010

also in the Polycom UI on the codec you have to tell the endpoint what the publicfacing address is that it will be NAT'd to as well as tell it that NAT is in use or else it will not work throughthe firewall.

Member Since	‎04-23-2010 07:22 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	4

User Statistics

User Activity

cisco-rdn - # forwarding not catching unity forwarding

cisco-rdn - # forwarding not catching unity forwarding

cisco-rdn - # forwarding not catching unity forwarding

Re: Polycom VC problem