Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Default FWSM inspection policyHow does traffic inspection works ?Traffic with Inspection On is sent to the Control Point for Deep Paket Inspection and tarffic not being inspected takes Fastpath.For ExampleIf I remove SQLNET from default inspection , ...
Users are facing issue since a long time now . Whenever user connected to wireless is idle say 10 -20 seconds he gets disconnectedThis happens for all the users and even Mac/Win 7I changed Activity Timeout on AP and even rebooted but still when I dos...
PC1 and PC2 are connected to a switchWill the swicth learn the mac-address and store mac in the mac-address table if PC1 and PC2 don't have any IP Address?There is no ARP happening and there is no IP traffic between them.Will a mac-address ping popul...
Is it possible to know the interface connected to a server based only on the Mac-address of server on a 6509?There is no IP on the serverThis is not possible as per my knowledge but I need some document showing that in order to send it to the client....
In other wordsI wanted to know traffic marked for inspection still takes Fastpath?For exampleIf Default Inspection is inspecting SQLNET , does it check the ACL in FWSM as well or it's by-passed and traffic is checked only on the inspection engine?
How does traffic inspection works ?Traffic with Inspection On is sent to the Control Point for Deep Paket Inspection and tarffic not being inspected takes Fastpath.If I remove SQLNET from default inspection , Do I need correct ACL to permit SQLNET fo...
