Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Which is the smallest/cheapest Cisco switch with dot1Q-tunnel support?I'm looking for a suitable CPE to terminate a fiber with at a customer location, so it needs at least one SFP slot and one 1000Base-T port for q-tunnel handoff.- Mat
Hi, I'm trying to get a new 2504 WLC working with a AIR-LAP1142N-E-K9. I'm a newbee to Cisco WLC's so right now I'm just labbing with a simple setup but am unable to get the AP to recieve an IP address from the WLC.I've configured port 0 as the manag...
I'm thinking of replacing our old HP based WiFi network with a Cisco controller based one.I'm thinking of getting the following:* Cisco 2504 controller with 25 AP license* 6 pcs 1142N APs for covering the office where most people work (about 25 peopl...
I just asked our Cisco partner about the 2960C and they first said it supported Q-in-Q, but when I then ordered it and they doublechecked with Cisco they came back and said, no it doesn't, the WS-C3560CG-8TC-S is the smallest switch with Q-in-Q suppo...
I've read the specs, but I can't find anything in there saying if it supports Q-tunneling or not Searching for 802.1Q Tunneling feature in the Feature Navigator only lists 2960S at Platform which indicates that the smaller 2960 and 2960-C would not s...
Is that a "real" Cisco switch running IOS just like the bigger 2960s?Does all 2960's running the LAN Image support dot1Q-tunnel, even the older 100M-models like WS-C2960-24TC-L?
Anyone got them working by enabling use of unsupported transcievers with the following commands without reprogramming them:service unsupported-transceiver
no errdisable detect cause gbic-invalidI just brought a few 3560X-24T-S switches with C3KX-NM-1...
