Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Aleksandar & the rest of the xr-team
I saw the Cisco live presentation BRKSPG-2904 from Barcelona this year. It was mentioned there that Flow label was going to be supported for pwhe. Has it been decided in which release this will be supported yet...
Hi
Noticed today that you have done some syntax changes between 5.2.4 and 5.3.4 when it comes to dhcp ipv4 snooping.
In 5.2.4
Dhcp ipv4interface [GigabitEthernetX/X/X/X.xxxx snoop information option format-type circuit-id test123
In 5.3.4 this se...
Hi
Is there a way to show current configuration in a context in configuration mode?
as an example
RP/0/RSP0/CPU0:9k(config)#l2vpn bridge group L2_DCS bridge-domain 502RP/0/RSP0/CPU0:9k(config-l2vpn-bg-bd)#
If i stand here the only way to see active c...
Hi
Just wondering why there isn't any input/output rate on l2transport subinterfaces.
L2transport subinterface
Bundle-Ether625.2204 is up, line protocol is up Interface state transitions: 1 Hardware is VLAN sub-interface(s), address is d46d.506e.03...
HiJust wondering what the thoughts was when the show tech command was designed in IOS-XR? Opened a case yesterday and was asked to do 6 different show tech captures. It took between 30 min and 60 min for each showtech file to run. That's maybe ok whe...
HiI know this is an old thread but saw this when searching for the same thing. Though it would be good to post an answer if someone else stumble upon this thread.You can use ip http client source-interface GigabitEthernet0To get copy http to work whe...
HiIf i don't remember wrong you get that error when you already have created an interface (default l3) and then try to convert it to l2transport without removing the old one. Try the following and see if it's work.no interface Bundle-Ether200.500no ...
HiYeah that will work. Just make sure that you pop tag on interface configurationSomething like this:interface TenGigE0/1/0/0.100 l2transportencapsulation dot1q 100rewrite ingress tag pop 1 symmetric!interface TenGigE0/1/0/0.200 l2transportencapsulat...
Hi
You need to add the satellite under the nv context
nv
satellite 100
type asr9000v
secret 5 xxxxxxxxxxx
description satellite connected to asr9k
upgrade on-connect
!
And then under the bundle-interface (this is called ICL) that is connect...
