Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cat 5513 with a RSM. The RSM has numerous Vlan's configured. I'll use Vlan 8 in my example.When I do a "Show Interface Vlan 8" on the RSM, I notice it says the bandwidth is 100mb. This is the same bandwidth listed for each Vlan in the RSM...
I have both MIC and TKIP enabled and working fine with my Cisco 350 AP's and Clients. (All new cisco gear). Both are at the latest versions of software and firmware.I wish to use LEAP with an ACS server.Do I need to turn off TKIP when I go with LEAP...
You have it right sort of...police on the port-channel and queue on the member links.This is an edited version for an example:interface Port-channel1 service-policy output SUP6E-EGRESS-POLICER!interface TenGigabitEthernet5/1 channel-protocol pagp cha...
I have a couple dozen 4500's with Sup-6E's. "show policy-map interface" counters are broken in the current code train your using. Its still not fixed in 12.2(53)SG train. It does not matter whether you use per-port or per port per vlan. I have bo...
With a WiSM, you should have a defined WiSM 'service' vlan in an unrouted range for WiSM to 6500 communications.Make sure that vlan is NOT trunked anywhere. Remove that vlan from other trunks.This solved my sporadic WiSM reboot issues.
On the port-channel members between a 3750 switch and the 4400 WLC, use:mls qos trust COS.Cisco had a bug a while back forcing you to trust DSCP on this link, but after V4.2, you should trust COS on that port-channel, not dscp.I agree that on switch ...
A previous poster was correct in that this problem occurs when a given device such as a laptop has two network interfaces active and one tries to renew its DHCP address by using the other. An example would be a laptop with wired and wireless interfa...
