About Martin W Joergensen

Martin W Joergensen · 07-27-2018

I've setup a new FirePower 2130 and I want to monitor the interface usage of it. I'm using Eth1/1-Eth1/4 of the device and they are configured and up Interface: Port Name Port Type Admin State Oper State State Reason -----...

Martin W Joergensen · 02-20-2018

I have a WS-C3650 running IOS-XE version 03.06.06E. I have two tacacs+ servers configured on it and I can login fine. I know that the primary tacacs server, server1, is working, but how can I test that server2 is working as well? When I issue the com...

Martin W Joergensen · 05-02-2017

I'm trying to look for an answer to what's the max ARP table size on a Cisco ASA 5555-X. Does anyone know how to find the answer? Is there a show command I can run or a spec sheet that shows the max ARP table size?

Martin W Joergensen · 07-29-2018

Hi DennisI discovered them using both SolarWinds and a snmpwalk. Both turns out with the same interfaces and speed

Martin W Joergensen · 02-26-2018

This is not the best solution, but it works. My solution will be to create a second group only with the backup server and then use the test command to test that group.I hope Cisco will add the ability to test a single TACACS+ server in IOS-XE in the ...

Martin W Joergensen · 02-20-2018

@Mark Malone wrote:Could you not temporarily remove the primary server ip from the AAA , that will force it to use the standby to make sure its working in test Unfortunately this is not an option as the device is under strict change control. I can't...

Martin W Joergensen · 05-03-2017

We're having an issue with a sensor device that is not sending any traffic when it's first attached to the network. The problem is on our production line when a sensor breaks down it is replaced within 30 minutes, but the ARP entry will stay for the ...

Martin W Joergensen · 08-02-2007

The AP is older than 07/2005.I continued to work on it and I finally got the AP to eat an IOS release and then I tried to run the conversion tool again. This time I got the SSC hash key and its working fine.

Member Since	‎08-01-2007 10:01 PM
Date Last Visited	‎09-05-2018 12:26 AM
Posts	9

User Statistics

User Activity

Interface monitoring of Cisco FirePower 2130

IOS-XE: Testing specific TACACS server

Cisco ASA 5555-X max ARP table size

Re: Interface monitoring of Cisco FirePower 2130

Re: IOS-XE: Testing specific TACACS server

Re: IOS-XE: Testing specific TACACS server

We're having an issue with a

Re: Blank config (0kb) csv file after success 1200 series upgrad