About jmille75

jmille75 · 04-09-2013

Is there a way to change the display name shown when in a multi-point call on an MCU? Currently it shows the h.323 ID, I am wondering if it is possible to show the SystemUnit name?

jmille75 · 03-27-2013

Currently have a cluster of three MSE 8510 blades running 4.3 and our media port mode is HD, allowing for 60 HD video ports and 60 audio ports.We just had a conference where the MCU would not allow any more than 80 participants (it was a mix of audio...

jmille75 · 04-09-2013

Saurabh,I made the change and it changes on the upper left hand corner of the home screen. But when I put the endpoint in a call, it still shows the h.323 ID.

jmille75 · 04-03-2013

Here is what I captured before I broke the boot sequence.

jmille75 · 04-03-2013

Tomonori,Once I get "$" and type in the "eee" command nothing happens? How long should it take to respond to the command?

jmille75 · 03-27-2013

Martin,Thanks for the quick response. To answer your questions:-We have our participant limit set to nothing-As far as setting the conference up differently, no we have not done that, we utilize TMS to schedule our calls, we currently have port res...

jmille75 · 03-08-2013

Ravi,I have turned CEC mode on, with the same result. I forgot to mention that if you unplug the HDMI cable and plug it back in the video is restored.I have not hooked up a different monitor because the output of the codec goes to an RGB Spectrum 3...

Member Since	‎12-17-2012 09:08 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	9

User Statistics

User Activity

Codec Display Name

MSE 8510 max 80 participants per Call?

Codec Display Name

1700 TANDBERG - system appears to be cycling through a reboot an

1700 TANDBERG - system appears to be cycling through a reboot an

MSE 8510 max 80 participants per Call?

C40 going into Standby