Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,
Can't seem to find the use of this command :-
xConfiguration Experimental Conference 1 PacketLossResilience ForwardErrorCorrection
Can somebody throw some light on it?
Thanks,
Saurabh Gupta
Hello Experts, I am trying to display lobby message on scheduled conferences from TMS running 13.2 and Telepresence Server 8710 running 3.1.I have enabled lobby screen for conferences in extended settings on TMS for Telepresence Server. And also I pu...
Hello Fellas, I have a new Cisco DX80 Endpoint registered on CUCM 8.6.2. I have other TP units which are registered on CUCM , the rest of the TP units ( CTS 3xxx, 13xx, 500, TX 9000 etc) were pulled into TMS via CUCM from managed Systems. However, t...
Hi Experts,Could you please let me know the pros and cons of using TX software on newly installed TX9000. Currently, I am running CTS 1.9.2 and we don't get the screen capture from TX9000 GUI . Cisco recommended us to use TX6.0 for TX devices.I am li...
Thanks Jens.
Do you know how this command is related to Jitter? We had one customer complaining about Jitter ? We ran this command and turned off the FEC and after that Jitter came down.
Do you know why? Now customer is asking how could this comman...
Hi Jens,
Thanks for your reply.
When I question this command on my MX700 running TC 7.3, it gives me these three options with default set to XORWithUniqueSsrc. Do you know what does this mean and the other two?
xConfiguration Experimental Conferen...
No, you cannot use EX90 power supply in place of MXP 1700. If you are not able to use MXP 1700, then please suggest EX90 as replacement to your customer for MXP 1700. As MXP was declared End of Sale/Life long back by Cisco and as replacement, EX90 we...
you need to install a Telepresence Server Bridge to have a conference for more than 2 participants. You can either install Telepresence Server on a virtual appliance or you can buy hardware appliance from Cisco.
Thanks,
Saurabh
Thanks Guys for your response. Sorry about the typo, I meant SFTP and not TFTP.
I installed FreeFTPD, and when tried to configure and save it, it gives me an error saying "Could not write configuration". Any ideas?
Regards.
Saurabh Gupta
