About mastrboy_

mastrboy_ · 01-31-2013

HiHave some questions about 4500-X series.- Do they come with redundant power supply's? Or do you have to buy the second one to get redunandancy?- Since the 4500-X supports VSS and Multichassis Etherchannel og layer2, can you configure a multichassis...

mastrboy_ · 05-15-2012

In the following scenario, how will the 2950/2960/2960S series behave:- VTP server/domain configured on a 6509- A access switch (2960) currently configured in transparent mode with all VLAN it requiresWill the switch drop any traffick if we change it...

mastrboy_ · 03-22-2012

We are looking into replacing our current Windows NLB configuration with a SLB solution as NLB creates some nasty multicast traffic. We are currently curious about the limitations for running SLB without a dedicated ACE Module, will it handle line-ra...

mastrboy_ · 02-27-2012

I have the following scenario i'm trying to solve:If client gateway = 192.168.64.9 then next-hop = 192.168.64.8 else use default-route 0.0.0.0I know it's possible to do a route-map match ip-address ACL list. But is it possible to match on gateway?Som...

mastrboy_ · 10-13-2011

We are looking into upgrading our 2x 6509-E in a VSS mode (VS-S720-10G) from 12.2(33)SXI3 modular to 12.2(33)SXI7 to non-modular version.Since we are moving away from the modular version can we do a regular FSU as stated here?:http://www.cisco.com/en...

mastrboy_ · 05-15-2012

If i remember correctly you need to configure IP DHCP SNOOPING and IP SOURCE GUARD.You can use this tool too figure out if your hardware/ios version supports this: http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

mastrboy_ · 02-27-2012

Almost. That is currently the solution we have using.But consider this, there are some clients on the same subnet which we want to route to a different IP. So we have the following config on the SVI:vlan x ip address 192.168.64.9 255.255.248.0 ip add...

mastrboy_ · 10-13-2011

Thanks...I also found a blog entry confirming that using eFSU would result in disaster: http://showbrain.blogspot.com/2011/08/catalyst-6509-e-vss-software-upgrade.html

mastrboy_ · 05-14-2010

Not much:# sh ip route summaryIP routing table name is Default-IP-Routing-Table(0)IP routing table maximum-paths is 32Route Source Networks Subnets Overhead Memory (bytes)connected 0 6 432 864static ...

mastrboy_ · 05-14-2010

Thanks, I'll read through them before i activate netflow.

Member Since	‎04-29-2010 06:53 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	15

User Statistics

User Activity

Questions about Catalyst 4500-X

Behavior when changing VTP transparent to VTP client

6509-E SUP720 and SLB Limitations?

Policy routing based on client gateway? (6509-E)

Upgrading 6509-E in VSS from modular to non-modular?

How to prevent the users with static IP's to connect the Network

Policy routing based on client gateway? (6509-E)

Upgrading 6509-E in VSS from modular to non-modular?

Re: 6509 high memory usage, any need to be concerned?

Re: Reducing netflow load