Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two router connect with 2M SDH link via WIC-2T and NM-4T.These two router can ping each other's interface address.But while we set up EIGRP at these two routers, the router will return error message like "Packet from ourselves ignored",and th...
The system return message like this"Tftp:PGM_NM=Configuration Archive:6721:TYPE=unassigned message type::SNMP error, %s Telnet: Failed to get the begining of the configuration file Ssh:PGM_NM=Configuration Archive:6737:TYPE=unassigned message type::F...
The 3662 crash after the CW2000 connect to network and enable CDP at the fastethernet port~The system return error messages below:00:34:12: %SYS-2-WATCHDOG: Process aborted on watchdog timeout, process = IP SNMP.-Traceback= 602DCE8C 602E0948 602D8C7C...
There is a Lotus Notes Server behind a PIX firewall, while it send the mail with microsoft office attachemnt to the Lotus Notes Server outside the firewall, the mail will be lost~But if i zip the file into .zip or .rar file and send it, there is no s...
I am so sure there is no loop on both side. And i have confirmed the the EIGRP router-id are different.Such a strange problem, i have check the Bug Toolkit, seems there is no BUGs about this error maeeage.Thanks,
Thank you for your reply~But the notes guys said that 2 notes servers just use port 1352 to communicate, for both control and data~and we just configure the outside server to communicate the inside server with port 1352 but no any other ports~so stra...
But there is no HSRP configured at the crashed device~Is the BUG means that the CW2000 device to check if the router is running HSRP and cause router crash?~
