Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do i disable notifications from being sent to external domain mail senders/recepients. I have an ESA deployment which sends notifications to both the internal domain senders/recepients and external domain senders/recepients. This creates a lot of...
Hi team,Ive got a virtualised firewall running 3 security contexts in routed mode. What am experiencing is that i cannot connect to an OUTSIDE host through the security contexts. From the firewall itself i cannot ping the directly attached host on th...
Hi support,I have a Cisco 2811 router that keeps crashing whenever i boot it up. I realised that it is due to some missing cards that were registered on the PCI Bus.Is there a possible way of makin it not refer to its cnfigrations during boot up. It ...
Hi,Am experiencing a very strange phenomenon which i hope someone can help shed some light. Am migrting a site from an old Cisco 3660 router to a new CIsco 3845 router. The old router had serial connections to branch offices configured as multilink b...
Hi,Anyone had the experience of interconnecting the CIsco MDS 9222i to an HP Blade system through the VC-FC virtual connect module?When i connect my MDS switch to the module, the VC-FC ports dont log in to the MDS. Could i be missing out on something...
Yes, each OUTSIDE interface for each context is a subinterface, strange enough one context is working perfectly fine and it's sharing the same physical interface but of course on a different subinterface and ip subnet. Do u reckon it's the MAC addres...
Yes am sharing the outside interface across the 3 contexts using vlans and subinterfaces. But all vlans on that particular physical interface are OUTSIDE interfaces for the respective contexts.Regards,
Hi Giuslar,Sorry for the delayed response on my end and thanks for your concern on my case. Attached is a txt file with information that would be relevant to you. Please check it out and advise me on where the problem could be.Thnks,
i wanna use the CLI though i also have the fabric manager at my disposal. would you kindlyshare a sanitised version of ur running config for the mds that does the FCIP replication to the DR i see if i can make head out of it then if i face any challe...
Thanks hershall, jst noticed that i had not enabled the npvi feature..after i did thateverything picked up like a breeze. It is my first time wiht the MDS but so far so good, good learning experience for me. Have you ever done DR replication using FC...
