About timothy.bailey

timothy.bailey · 04-02-2013

Hi;I have an issue wherein the media fails on analogue calls in one direction only.Analogue connected to fxs port dials out over SIP trunk to IP handset on CO switch. After 30 seconds media from analogue fails but still works from CO switch.voice-po...

timothy.bailey · 07-19-2013

If you are terminating calls, E1/T1 or SIP onto the 2801 then you will need to configure the router. This is because the authentication will be handed by the router along with the sip connectivity. You will also need to put in the ITSP ip address or ...

timothy.bailey · 07-19-2013

You need to use keepalive mechanisms to shut down the dial-peers that are not available. This will prevent routing loops. Run sh dial-peer voice summary to see what peers are up when the PRI's are down they should be in a busy state. If they are not ...

timothy.bailey · 07-19-2013

As this will be a new data circuit my first step would be to test for packet loss across the circuit. If this is good then try a softphone from a laptop directly into the router progressing into the network.2 way rtp failure is nearly always a networ...

timothy.bailey · 04-11-2013

EdsonWhat would the correct configuration be to get the CUBE to respond to another SBC when it sends the CUBE an OPTIONS-PING message?At present it is rejecting the message saying it is not recognized?

timothy.bailey · 04-10-2013

So thanks for the assistance. After several wireshark traces and alot of percerverance I found that what was happening was the following:CO Switch setup the call CUBE terminated and negotiated the rtp ports.CUBE sends re-invite advertising its RTP po...

Member Since	‎04-02-2013 12:58 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	15

User Statistics

User Activity

FXS one way media failure on VIC3

Re: ip to ip gateway functionality

Re: Outbound dialing with Multi-site PRIs and H323.

Re: Two way audio issue

Ask the Experts: Configuring and Troubleshooting Cisco SIP CUBE/

Re: FXS one way media failure on VIC3