Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can ping the host that is on the other side of the ipsec tunnel but i cannot monitor it via SLA.
PCVST-ASA# ping inside 172.31.56.152Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 172.31.56.152, timeout is 2 seconds:!!!!!Success ...
I have a IPsec tunnet to amazon VPC client.
The tunnel is up and the VPC side can get access to my resources but I cannot get access to VPC side.
The client claims that inbound security rules are setup to allow my subnet.
How can I troubleshoot if my...
I have a IPsec tunnet to amazon VPC client.The tunnel is up and the VPC side can get access to my resources but I cannot get access to VPC side.The client claims that inbound security rules are setup to allow my subnet.How can I troubleshoot if my pa...
The asa is configured as cluster of 2.It was working fine and out of nowhere the users cannot login to any-connect anymore.
The asa reports the session limit of 2 error.
The license shows:
PCVST-ASA# sh activation-keyLicensed features for this pl...
After importing custom snmp MIB and deploying it I cannot find where can I see the pulled data?Where do I go to create custom report or custom dashlet to show data pulled through custom mib and custom snmp template?thx
Real devices.
I don't think it is relevant what is on the other side of the tunnel as the ping works when executed via terminal session. It is only failing for the SLA monitor.
yes amazon says in their guide:
"
! This access list should contain a static route corresponding to your VPC CIDR and allow traffic from any subnet.! If you do not wish to use the "any" source, you must use a single access-list entry for accessing th...
