Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2811 Router (config below) with VPN configured. I can connect through the VPN and access devices on the native VLAN but I can't access the 10.77.5.0 (VLAN 5) network (I don't care to access the 10.77.10.0 - VLAN 10 network). This issue has...
I have a 2811 that I can remotely VPN to using Cisco VPN client however I cannot see the internal admin network (10.35.5.0). I believe it has to do with a missing acl but not sure. Please take a look at the config below and let me know what I am mi...
I am attempting to setup remote VPN access for clients but have been unable to connect remotely using Cisco VPN client. Here is the current configuration on the router. I think I'm almost there and may be missing a couple commands. Thank you for l...
Thank you for taking the time to look at this discussion. I am trying to setup remote client VPN and my attempts have failed. I would like Administrators to be able to VPN in using the Cisco VPN Client with a local login and password on the router....
I have a 2960 SI lan lite switch that I am conifguring for admin and guest access. I have wireless AP's plugged into trunked ports 2 and 3. I am using two vlan's (in addition to the native VLAN). Vlan 5 for Admin and Vlan 10 for guest access. I h...
I entered that command and noticed that I still lost VPN and remote SSH access when I entered permit ip any any. So I tried the following combination of what you recommended and my previous config and everything is working correctly now. This is w...
Andrew,Thanks for your recommendations. I rewrote the extended vpn acl however when I rewrote the extended NAT acl as you have listed I lost all remote access (ssh and vpn) to my network. Once I got home I reset the extended NAT acl back to the pre...
