Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello tbabineaux,I have not encountered the issue with two policies having one subnet on 10.0.0.0 and the other on 10.1.1.1 /24. To create the second policy it will have to have its own VPN and IKE policy. You will not be able to use a second IKE p...
Hello tbabineaux,You will have to create two IPsec VPN policies. One using the remote local subnet of 10.0.0.0 and the other policy using the remote local subnet 10.1.1.0 of the other VLAN. Hope this helps, Michael D.If this post is helpful please ...
Hello SPA52GUser,Depending on your phone system if you have the option of configuring a dial plan using a prefix then the extension user to send the call directly to VM for the call routing. Example the UC500 series used the prefix 6 then the extens...
Hello raul.gadea1,What you will have to do is configure another VPN gateway to gateway tunnel and in the remote subnet setting put in the subnet of the other VLAN. This will allow the pass through of the subnets over the VPN tunnel/s.Hope this help,...
Hello stephan.kambor,Make sure you upgrade the boot code to 1.3.5.06 via TFTP first before you upgrade to the firmware 1.4.1.3. Basic firmware upgrade instructions:Upgrading from Versions Earlier than 1.3.5When upgrading the device from version prior...
