Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 3 new MDS 9222i's shipped with NX-OS 5.2(2) and we upgraded to 5.2(6b). Under both release we had some issues with the Ethernet interfaces not coming up. I think it may be due to issues with auto speed and duplex negotations. So configured ...
Hi There,I have one ACS SE 1113 and another SE1112. Both devices are running 4.2.0.124. I setup both devices and had replication working properly local just yesterday. The 1113 was on one subnet and 1112 on another. It worked perfect. I moved the...
Equipment: I am running ACS 4.2.0.124 on a SE 1113.Issue: I am getting two "self" entries under AAA servers. One is the actually IP address of the ACS SE. I am wanting to replicate at some point. Any idea how to get rid of the loopback? I have alr...
Chris,Thanks for the input. I do know that show run only shows non-default. I guess I was not clear, this is for the gigabit ethernet ports. Here is what I mean, if you notice after each command to set the duplex, when I do a show run, it show noth...
Hi there, I actually had to do a hard reset on the ACS. Disclosure thou, I had replication working in our computer center before I moved it. Once I moved it to a different site and Re-IPed is when I ran into problems. I simply just power the box d...
Actually I finally got it resolved. I went back over to the DR site and put a sniffer on that side. I was getting the same kind of traffic.I just hard reset the box and power it back up. Now it replicates just fine again. Go figure! Thanks for t...
I was able to do traces on the ISG 1000 using "debug flow drop" sourcing on the ACS Ip. It looks like one of our Juniper here (locally) is dropping packets.**** jump to packet:172.16.17.14->172.16.111.14 flow_decap_vector IPv4 process flow packet ...
