Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a switch that does not support Intelligent Power management (IPM) and I want to use a PWRINJ3 to power up the AP1242 with 2 radios installed. I want to use CDP on the ethernet link.Is there a way to turn off the power negotiation without turni...
I was wondering can help me with this error message or point me to a document on CCO that goes into detail about the boot process of a SUP720 running code 12.2(18)SXD4. %PFREDUN-SP-4-BOOTSTRING_INVALID: The bootfile slavesup-bootf...
I am looking for some guideance on troubleshooting the following problem.Catalst 6500 with a WS-SUP720-3B running 12.2(18)SXD4 code.All ports setup as follows.!Interface gig X/Y switchport mode access switchport access vlan 1 spanning-tree portfast n...
The reason I ask is that we stage APs for the field and the question was asked, if you do all the configuration for the LWAP on the controller then what happens when you take the LWAP off the staging controller(configured exactly as the production co...
