Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Is there an issue to run powertool with powershell on Linux.I installed powershell on RHEL, and I try to run cmdlet from UCS Powertool, but it doesn't work.I copied Module directory from Windows into Modules directory on Linux (in to /opt/micro...
Hello, since i upgrade my central in 1.3(1a) I have a pb on clock of UCS Central, not for clock in domain definition.In GUI I defined TimeZone "Europ/Paris" in "Administration", "General" (old GUI). But this GUI and CLI show a PDT clock not CEST as b...
To check compatibility between our Cisco MDS 9000 and UCS Manager, is there a correspondence table betwenn the UCSM versions and the NXOS versions inside ?Example : the last UCSM 2.2(1b) contains nxos 5.2(3).It seems this nxos version is not compatib...
Hello, I finding a old fault, which has been cleared of the faults view. I don't see it in Events view. How finding a old fault ?Thank for your help.Stéphane
Hi,In Internal LAN section, I have a port-channel with no members. When I try to delete it with GUI, I have an error "Port channel cannot be deleted". With CLI, I only can delete member, but I have no members.Thanks for help Stéphane
Hello Sumanth,Thank you for this information.StéphaneDe : Sumanth B R Envoyé : mardi 20 décembre 2016 04:47À : Tailpied StephaneObjet : Re: - powertool on LinuxCisco Communities <https://communities.cisco.com/>powertool on Linuxreply from Sumanth B ...
Hi,
After "debug hardware internal carmel clear-counters error", does it make a reset of IOM ? because I have always the CRC error in GUI, in fabric ports of IOM chassis.
How can I have the CRC counter of theses fabric ports in CLI interface, becaus...
