Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a small network based GRE-tunnels (IS-IS)
When I add a new network device that should connect to this network using OSPF, the whole network and all GRE-tunnel goes down.
Tunnels and network returns UP again after OSPF is turned from t...
Hello, I have two ASA-sites, Site A and Site B. ASA type is 5512-X. In Site A there is a router behind ASA which I try to ping. When I try to ping from Site B (192.168.11.11 laptop) to Site A Cisco router's management address (192.168.100.1) Site B A...
Hello, I would like to have SSH management connection from my local LAN laptop to my ASA-firewall. Management connection is red color line, see attach. SSH is configured and tested and it's allowed to take SSH connection from local LAN to ASA. But la...
Hi, i have VPN-tunnel up between ASA5512X <-> ASA5512X.There is one laptop also connected to both ASA's LAN-port and ping between these laptops through tunnel success 100%. But when I remove another laptop and replace it -> router device with same IP...
Hi,I am unable to call one of my SX20 via phonebook.When I make a new call and select from phonebook the right device -> I get error message "cannot connect".But when I call to the same device entering just device IP-address -> call success!There is ...
Hello,
I just uploaded a network diagram which contains some configuration lines. So when I start ospf from firewall interface, all my IS-IS network side goes down.
One another question about route maps. Not relating this case.
If I have for examp...
Hi Karthik,I configured static NAT to both sites. Do I need add any static routes for new networks (221.0 and 222.0) after I have configured static NAT? Here is my NAT -configuration, can you please check is it right? After this configuration I was s...
OK, here...It seems that tunnel between my LAN-to-LAN network 11.0 <-> 20.0 works?But I would like to use my management network 100.0 at Site A and also at Site B. How this should be configured that from Site B (management address 100.5) can have man...
OK, I will add those ACL's and see what happens. Yes, I have configured site to site VPN. There is Ipsec up, VPN-led lights. But VPN statistics shows only IKEv1. I can' see IKEv2 nowhere else. Is there configuration error of VPN-tunnel because i can'...
Hi Marius, I added command management-access managent to both ASA. I also added to both devices crypto ACL that from source Site A management and LAN network -> destination Site B LAN and management is allowed.And from source Site B -> destination Si...
