Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'll need the following ports to be open for incoming traffic to the 3CX.
PBX 3CX WebRTC / UDP 9256-9500
PBX Web Access 5001 / TCP 5001
PBX Media Server (RTP) / UDP 9000-9255
PBX Phone System (SecureSIP) / TCP-UDP 5061
PBX Remote Tunn...
Hello,
All of a sudden our Anyconnect clients can't connect to our network via VPN. We use both the 2.5 and 3.1 versions. When we enter the IP address it connects fine to the Cisco Router and is prompt for authentication. We enter username and passw...
Hello,
At some point Cisco Real-Time System Loggin was turned on via CLI and whenever I use putty now to go into the CLI the real-time logging is running. I can't stop it. I tried everything I know, ctrl-z, q and nothing is stopping it.
Can someone...
Hello Folks,I have a Cisco ASA 5505 and I just setup a DVR system at our office. Everything works fine inside where we can go directly to the IP address 10.11.15.90, but we would like to also be able to access it from the outside as well.I am not to ...
Thanks for the response, but I think upgrading the ASA to 9+ version will allow me to do ranges. This method would mean I have make a line item for each port.
Thanks for the response, but that is not what I was asking. I don't want to know what the logs are showing, i know this information.
I want to know how to stop it from running whenever I open up the CLI.
Thanks
