Level 1
Level 1
Member since ‎01-20-2013

User Statistics

  • 23 Posts
  • 0 Solutions
  • 5 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
10 Replies
5 Replies

User Activity

Hello Everyone, I have this two switch and one router configured as router on stick. ---Switch1--- int gi0/1 is connected to Router1 int gi0/1 switchport mode trunk, switchport trunk allowed vlan 1,10,20 int fa0/1 is connected to Switch2 int fa0/1 ...
Hi,I made a table for OSI model and TCP/IP model and diffrent protocols. If you have any additions, comments feel free to reply. There are a lot of protocols out there and these are only few and I want to separate each protocol to its correct layers....
Hi,Can someone help me to find the cisco official definition of hub, bridge, switch and router. I mean i know how these devices works, i just want to read how cisco defined them. Thanks.
Hi Everyone,I need help regarding access-list. I really don't understand the concept of outbound and inbound.This is working fine, but my question is when i put the access-group in serial interface of router 0 the access list won't work.Please Advise...
Hi Everyone,I have here a configured RIP scenario.It was configured using RIP version 1. In my understanding RIP v1 supports classful network, but when i check the route of Router 1, the RIP acknowledge the network and network Ro...
Community Statistics
Member Since ‎01-20-2013 05:55 AM
Date Last Visited ‎08-19-2022 12:03 AM
Posts 23
Helpful Votes Given To