Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please someone help me deschiper the QOS on our legacy distribution switches, these are the switch connecting to our closets, each port is a fiber trunk back to the distribution. I'm assuming this is the egress queue, I have some understanding of wha...
At work recently I have run into a problem where on my 6500 switches I see, continuous ports errors accumulating, the network does not seem to be slow but the errors are in the millions for more then 70% of all ports. This is happening on many switch...
I'm trying to simulate a tunnel through a service provider:I have 3 Routers, which are connected with static routes and are all pinging each other other through serial and fastethernet interfaces.Router 1 and Router 3 are acting as tunnel endpoints. ...
I'm trying to translate my inside network of 192.168.20.0 to my outside ISP address on ASA 5505. The ping from all hosts to 4.2.2.2 works, butit still only let's one address out to translate.My configuration is: global (outside) 1 interface nat (insi...
I'm trying to translate my inside network of 192.168.20.0 to my outside ISP address on ASA 5505. The ping from all hosts to 4.2.2.2 works, butit still only let's one address out to translate.My configuration is: global (outside) 1 interface nat (insi...
So basically If an interface is configured at half duplex going through a cat 5 cable, some will most certainly collide. So what would be an optimum configuration for ports that cause no collisions with cat 5 cables for regular users?
