Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi have the following situation:A cloud providor offering L2L ipsec VPNs.I have 3 offices globally. They are currently all routable between each other via VPN links.I want to introduce a new VPN from each office to the cloud providor offering up the...
Hi all,I have a PIX-515E version 8.0(2).I have two remote sites connected to this PIX via IPSec tunnels.Each remote site can reach the local networks behind the PIX but I can not reach remoteSiteA from remoteSiteB.So,10.30.8.254 SiteA <----- IPSec --...
Hi all,I have a Cisco 2811 with an additional HWIC-4ESW card.Fe0/0 is my WAN port to the InternetFe0/1 is P2P link to another locationFe0/0/0 is a trunk port to a Catalyst 2650 switchFe0/0/1 is also a trunk port to a Catalyst 2650 switchFe0/0/2 is a ...
I've just set up dialin VPN on my PIX 515e. The users can connect fine buta) my split tunnel ACL is not applied andb) I have the following error in syslog No translation group found for udp src outside:10.0.56.2/137 dst inside_lan:10.0.8.6/137If i t...
Just when I think I've got my head around nat, global and static commands i find myself struggling to get this 'simple' config working...I have a pretty default config:interface Vlan1 nameif inside security-level 100 ip address 10.20.30.50 255.255.25...
I am unable to use the switchport command on the interface I am currently using however it looks like if I change the interface to the HWIC card (FastEthernet0/0/0) then I can issue the command. What is the difference between the inbuilt port and th...
