Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking for a layer two switch series or model that supports the following:802.1XCoA (RFC 3576)802.1X failover I can find switches that support 802.1X but I am struggling to find any documentation on Cisco switches that support CoA and 802.1X fa...
I have taken over the support requirements on a wireless network utilising lightweight access points, a 5508 wireless LAN controller and a Prime Infrastructure NMS and it appears to be underperforming. How can I display the transmit/receive retry an...
We have been asked to extend an exiting wireless network utilising an ACS 1200 appliance for PEAP MSCHAPv2. The ACS is currently configured to check a single security group for membership and then grant/deny access.The customer has supplied 26 OUs a...
I have inherited a high density network comprising of older Cisco access points and the wireless clients are failing to roam. After a site survey I have found that the network is too "hot" with a large number of access points visible in almost all ...
I saw the per client analysis but we are talking several hundred access points with a huge number of clients. I was more looking for a table or report on the access points.
Scott,Thanks for the reply.I thought of using shadow groups with a PowerShell script to update the shadow groups but as my customer is a large multi-national running this type of script would not be acceptable. Is this what you were thinking or is t...
leolaohoo, Thanks for the advice. My site is a 24x7 facility where the wireless network carries voice traffic so to make any changes I have to provide full documentation before change approval will be granted. This is is reason I am looking into ...
I am looking at reducing the access point count in this area (I can always these access points in other areas of the site) and using the TPC to "smooth out" the rough edges.