Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to make some test with two ASA 5505; one has software version 7.2(4) the other 8.2.I would like to make a sit to site VPN from the two device.I followed the VPN site to site wizard on both machine with the correct parameters, but it does'n...
Trying to set Outside inteface to DHCP with commend:ip address outside dhcp setrouteAnd receive this error:DHCP command failedThis problem also during the config factory-default procedure.The Firmware is Cisco PIX Firewall Version 6.3(5)Cisco PIX Dev...
Hi everybody,I have a IP surveillance camera (192.168.1.125 on port 81) behind a Firewall ASA 5505.The outside interface (192.168.0.1) is reachable by a public address, inside interface has a private address 192.168.1.254.I made a Static Route to re...
Tks Soeren for your help, these are some info about my test:Cisco 1 (7.2) Ext 192.168.0.1 Int 192.168.11.50Cisco 2 (8.2) Ext 192.168.0.2 Int 192.168.10.254Common gateway 192.168.0.254Both Ext interface of Cisco 1 ...
Great Jon,the error during config factory-default put me outside right road.With a DCHP server connected, now I don't receive more error.I was trying to make a standard scratch configuration, without anything connected, and this was my error...!!Now ...
pixfirewall(config)# sh interface interface ethernet0 "outside" is up, line protocol is down Hardware is i82559 ethernet, address is 000f.f7de.bc4d ...
I mistake writing the post....In Console I wrote correctly ip address outside dhcp setroutePlease note that during config factory-default command, the Pix give me back dhcp command failed, exactly the same error message.
