Thanks Jason :) ... View more

Following up on this thread, in a wireless guest environment, if a user connects to the guest ssid, and opens the login portal but does not actually login, is a base license consumed? ... View more

Resetting the config doesn't work either. ... View more

Suddenly, when I click on the wireless setup tool, I get a page that's stuck in loading. I tried to enable/disable wifi setup via the CLI, that didn't help. Any ideas on how I can fix this? Thanks ... View more

You nailed it. Thanks very much for your patience. Cheers ... View more

Hey Jason, something weird is happening with the tool, or perhaps I'm doing something wrong. I reached step 3 in the wireless setup where I selected the sponsor group from my AD. When I click commit, I get a message:" no Active Directory by the name of domain.com found" See here: https://www.screencast.com/t/chCC3CBQ2rK I can confirm that all my nodes have successfully joined the domain: https://www.screencast.com/t/6S2fmKrV Any ideas on what could be causing this issue? Thanks ... View more

Hey Jason, I'm in the process of creating a sponsored guest portal. I have joined the domain and now selecting a sponsor group. Can you please confirm if the sponsor group selected is the group that will be allowed to create accounts for guest users? ... View more

Ok, I tried that. When I went to option [17] it said that the wifi is currently running. I tried to disable it, and then re-enabled it again. Logged off the gui and logged back in and it was still not available. I want to try to reset the ise config and start over with a clean slate. Are the steps I listed in the previous post correct? ... View more

Ah, excellent. I'll try that. Thanks a lot. P.S: Your videos on YouTube are very helpful ... View more

Hey Jason, quick question to make sure I'm doing this correctly. My system has an administrator node, a backup and 2 PSNs setup in failover mode. Now in order to run the wireless setup tool, I understand that I need to wipe the previous configuration using the "application reset-config ise" command. Now when I tried that I got a message that I should deregister the nodes prior to running the command. So, If I understand correctly I should follow the steps below: Deregister all nodes Run the "application reset-config ise" command on the admin node Register all the nodes and setup the failover again. Run the wireless setup tool. Am I missing anything? cheers ... View more

Thank you Jason. I read in the document that it's recommended to use the Wireless Setup in a standalone environment. Will I mess things up if I try it in my distributed environment? It's not yet in production by the way. My goal is to get a basic configuration up and running and fine tune it later on. Thanks ... View more