Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am trying to create NAT on a 9.0 ASA, I am trying to convert from PIX 7.2, the sample config is below, I cant figure out what the correct syntax is in the now ASA 9.0 syntax. Can someone please help me?nat-controlglobal (Outside) 1 24.55.15...
Is it recommended to place my ASA before the router? I want to terminate all of my VPN traffic on my router. So it would be Internet -> ASA -> router -> usersThank youSent from Cisco Technical Support iPhone App
Hello,I have a question.I have a customer that has to be added to another network through Site-TO-Site VPN. However the customer has a ip address network (192.168.0.0 255.255.255.0) and the network that they need to be connected to has a DMZ zone of...
I am trying to create a site-to-site VPN tunnel from a Cisco RV 120W behind a AT&T Uverse router to connect back to our corporate office. I have it connected but I cannot connect the VPN to it because I am behind this other router, all I get in the ...
Thank you Jon for the information, it really is very confusing to me, I am used to pre- 8.3 code. Below is the ACL to the NAT statement above, any help would be appreciatedaccess-list inside_outbound_nat0_acl extended permit ip 10.0.0.0 255.255.0.0 ...
Thank you Jon for the information, it really is very confusing to me, I am used to pre- 8.3 code. Below is the ACL to the NAT statement above, any help would be appreciatedaccess-list inside_outbound_nat0_acl extended permit ip 10.0.0.0 255.255.0.0 ...
How can I allow the VPN traffic through the ASA and terminate on the router? Is this possible?Internet -> ASA -> Router -> UserSent from Cisco Technical Support iPhone App
