Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Where has the configuration:
Router(config)# control-plane hostRouter(config-cp-host)# management-interface FastEthernet 0/0 allow ssh snmp
gone in IOS 15.4?
This used to allow one to secure management plane traffic to specific interfaces so that th...
Hi,I have a WS-X4548-GB-RJ45 installed in a 4506E Chasis. According to the Cisco documentation it states: Bandwidth is allocated across six 8-port groups, providing 1 Gbps per port groupSlot Bandwidth = 6Gbps My understanding is that this means each...
I would like to be able to have my PE Device perform encryption before dropping a packet onto the MPLS network.Effectively, I am looking for the ability to apply a GDOI-Crypto-Map to a MPLS interface.Traffic received on the VRF-PE Interface is encryp...
No, it's just a standard local username/password. Command certainly isn't there for me...
rtr1#conf tEnter configuration commands, one per line. End with CNTL/Z.rtr1(config)#conrtr1(config)#contrtr1(config)#control-plane hostrtr1(config-cp-host)#?...
