This sounds normal as when performing zoning you would only usually ever use the WWPN. If all you wa...

I got it working in the end by rebooting each host and then doing another VUM scan. That made the er...

I get the exact same error message about an incompatible package following this procedure. Did you e...

Will there be a Cisco customised ISO for vSphere 5?Or have all UCS drivers and CIM providers been in...

I got some tentative dates from TAC for anyone who is interested:iqn initiator pools: early next yea...

I've done a couple of upgrades to 2.0(1q) now. All using vSphere 4.1 and all went without a hitch.On...

I've set it up for one customer and found it much harder to get working than FC boot, although it ha...

Is there any way to capture failed logon attempts in UCS? I see allowed logon attempts in the audit ...

Thanks again Robert, I have logged the following:619380901 for iqn pool619380941 for vSphere 5 suppo...

Does anyone know if\when the following features will be available?1. iSCSI boot support for vSphere ...

Here are some screenshots of the config I used to get this working.That compatibility guide does see...

Thanks both for the tips. I eventually did get it working. My problem was the iSCSI authentication p...

Thank you for that, very useful stuff as I'm knee-deep in an installation right now!Couple of follow...

I'm setting up iSCSI boot for UCS 2.0 and have a query about the 'Set iSCSI Boot Parameters' page.Wh...

Thanks Richard. I'm aware of that doc and the caveat does not apply in this case as I'd only be usin...