Hi Ken,can you please run the packet tracer command as follows : packet input inside icmp 10.15.16.2 8 0 10.1.1.15 detailedand share results.Regards,~Harry
Hi,Well the issue happens when the content get re written by the ASA, doing smart tunnel bypasses the content rewrite.if it gets you working, i would say that is the only way to go regards,~Harry
Hi,there seems to be some mismatch at phase 2 config, could you please confirm with the other end about the settings.if possible please post a config from there end as well.Regards,~Harry
Hi Stanley,good to hear, and you are welcome, for rating, please see the stars at the bottom of the discussion.Also please mark this post as Resolved, Happy to help~Harry
Hi,The phase 1 seems to be up, but the phase 2 isn't. it could be a mismatch in configuration from the other end too, could you please turn on debugs (and log it) and try to bring the tunnel up. please share those debugs for analysis.===debug cry is...