I'm adding a second post in this section in case I miss the right folks.I have several production VLAN's that I am going to be removing from the FWSM. I wanted to see if anyone out there had real life experience of the effects and connectivity issues...
I have several production VLAN's that I am going to be removing from the FWSM. I wanted to see if anyone out there had real life experience of the effects and connectivity issues (if any) during the removal of the VLAN's from the FWSM. How much conne...
I have a 6509e w/ Sup720 and Visual ASE 10/100/1000 (1 port) I want to SPAN traffic to. I am running IOS 12.2(18)SXD7 and wanted to know if later releases allow for traffic to/from the ASE in addition to the SPAN traffic so we can manage the device c...
I just upgraded a PIX 515e w/ 64MB RAM and 16MB flash from 6.3.4 to 7.2.2 and then to 8.0.3. Here's the contents of my flash:pix# dirDirectory of flash:/3 d--- 384 09:16:26 Jan 30 2008 lost+found7 -rw- 7280640 12:15:44 Jan 30...
Anyone seen this hardware's CPU hit in the 90% range with only 50Mbps traffic, ~50-70Kpps? Router has 1 - POS interface and 1Gbps interface in use. All traffic is legitimate VoIP and GRE.
This fw conf snippet says its config'ed as secondary. What does the other one say? All 3 devices connected to single switch? What do those port configs look like?Sent from Cisco Technical Support iPad App
you can a) setup a monitoring only ipsec vpn tunnel and add "management-access inside" if you REALLY need to ping or b) if you only need to monitor the inside interface status, you can just ping a device on the internal network like a switch or serv...
i understand how the asa hardware failover works =) thxmy very sentence is exactly how i approach every question posted here - you never know how you are going to interpret the question(s) upon reading them and you never know if the customer is going...
