Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi guysI'm having an issue tuning my IPv6 outbound flows on the ASR1001-X (1Gen) and my struggle is that MTR is now showing the IP address of the router itself or showing the packet loss on the level of 90%. All other hops are fine and at the end my ...
all sorted. found the reasons of RPF supressed drops.I was having a missing line on the Po1.vlan interface. now the interface works perfectly fine and its config looks as following:interface Port-channel1.xxxdescription ISP-L3-LACPencapsulation dot1Q...
seems not many of you cares here, that's my last reply though. sorry folks but I don't have much time to spare updating that post over and over again and have just one reply from BB so vague it's quite hard to say how useful this forum become.I know ...
One more hint whoever is willing to help:If you guys could please have a look at all this otherwise I have no choice other than rising a TAC case as my IPv4 via the very same device works fab but IPv6 flow is severally interrupted by that ASR which d...
no errors on aggregation lacp on QFX (2x10G from ASR). no issues at all butASR has on Po1 mtu 9216ISP ISR 4431 has mtu 1514 but QFX (core switch) has a port for both, ASR and ISR andwhilst ASR on LACP 2x10G has mtu 9216ISR (ISP rtr C4431) have no mtu...
one more detail, the 20G LACP link to that ASR Po1 is the Aggregation Interface terminated on Juniper QFX and stats from that interface looks as following (current snap):Physical interface: ae0, Enabled, Physical link is UpInterface index: 640, SNMP ...
