Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I cant seem to telnet to other devices from a cisco catalyst switch whenever ip routing is enabled on the switchSince enabling that throws the switch into L3 mode and the ip default-gateway becomes obsolete what can i do?
So i setup a failover active / passive with 2 ASA5520'sPrimary asa has 750 Anyconnect vpn licensing and the secondary asa has 2 Anyconnect licenses I haven't setup the second asa with the new 750 licenses i purchased but when i do a show version...
Hi allIm trying to figure out how to get network scans and dos attacks to show up in my syslog server for my CIsco ASA 5520. Just with the basic IPS support on the device i cannot seem to get anything to show up on my syslog server?Network scans dont...
Currently have a Cisco ASA5520..there is an internal application that communicates on port 80 with an outside host but is not HTML protocol.the ASA seems to block this traffic... any idea why?
Very strange problem... when we put a port back onto a static access vlan port from a 802.1x configured port... basically removing the 802.1x configuration on the port and reconfigure back to static access vlan port the host on the port can no longer...
The current output is !policy-map type inspect dns preset_dns_map parameters message-length maximum 512policy-map global_policy class inspection_default inspect ftp inspect h323 h225 inspect h323 ras inspect netbios inspect rsh inspect rt...
ChrisThe way have been simulating the issue is by leaving the host plugged in.1) Remove all the dot1x commands on the interface2) Readd the static access vlan commands on the interface3) Test it (Still no address for host even a manual dhcp renewal)4...
