Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have 3-port etherchannel on gig interfaces between 2 6500 routes. These two 6500s uplink to 7206 running MPLS over Ethernet."mpls mtu 1530" is configured on 7206 interfaces connected to 6500s. Now I want to configure plain-vanilla "mtu size 1530" ont...
Getting the NAT: % Invalid Key lengths for tree insertion message on (5) 2800 routers in different locations running IOS 124. It is not impacting production. Checked cisco.com and did not come up with anything. Does anyone have any feedback/info reg...
Have 2948G L3 running cat2949g-in-mz.120-25.W5.27b.binconfig register = 0x2102I enter some config statements, then save via wr mem or copy runnng-config startup-config, then reload router...the config recovers.But If I manually power cycle the route...
We had a 6509 hybrid switch reboot recently and we ran in to problems restoring the config. We eventually restored the config but the issue of boot variables and switch.cfg files , etc. is still ringing in our heads. .We were told that the switch cr...
Receiving syslog message :%SIP-3-UNSUPPORTED: Unsupported ptime value. But we have no SIP-related commands in our config. We reloaded router Friday eve 1/15 but two more %SIP-3-UNSUPPORTED: Unsupported ptime value messages re-appeared on 1/18. The r...
Yes, same issue on all 3 gig ports in etherchannel. The etherchannel has been in production for quite some time and there are no problems and yes all physical links in the etherchannel have the same MTU size which is 1500 bytes verified when I do a "...
Good question. I was trying to deploy two standard ACL's plus a login banner. When the job started failing I split it up and saw that the ACL change succeeded but the banner login failed and that's when I started to post. I just saw that under Task s...
