Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiCan anyone explain the following.At times when I issue the following commamand sh crypto session detailThe status shows the following. Session status: UP-NO-IKEHowever, traffic is following between the type nodes running IPSEC. How can the session ...
HiI have an interesting fault which is locking up telnet session when issueing certain commands i.e. "show run" works ok but "show proc cpu" always locks up the telnet session. Routers are connected via frame-relay. A Colleague suggested pinging the ...
HiI have an international circuit with the following configuration. Is this correct? Will G.704 at one end and G703 -> X.21 work ok.A end - 3640 with a E1 G.703 card running in framed mode (G.704, 1984k) connecting onto G.703 International CCT.B end ...
Hidisable "soft-reconfiguration inbound" on both peers (see below). soft-reconfiguration stores another copy of the BGP table prior to applying any filters! Not recommend when receiving the full Internet routing table.router bgp 22999no neighbor 64....
Thanks for your response.The G.703 -> x.21 converter has now been set to unframed E1 (g.703) and the remote end router configured for unframed E1. Circuit is currently running clean.I think the problem was related to the remote end modem, which is on...
Answers to your questions.1. Yes, the circuit is up. 2. Input errors on cisco router at the A end, which increase with load.3. unknow at this point. We don't manage the router. we just provide the circuit.4. A end Config!controller E1 0/1 framing NO-...
