Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, just discovered that 3 out of over 200 of our routers are having issues with our management station as they have the same snmp enginerID !?!Deployed snmp v3 to over 200 routers and all functioning fine, however have found 3 routers, 2 running 15....
Have issued login on-failure log and login on success log commands, however only the on-success works and puts output into log, the on-failure command does nothing.If I issue the additional command login block-for this causes the on-failure to work, ...
I have several daily reports that run against syslog.These worked fine until 31 Dec but since 1st Jan they show successful but empty. Checking syslog for the devices shows they are logging to syslog fine
Hi, I used a template copied to 180+ Cisco 1801 routers and had no problem with them (although they did not have embedded service engines) All I set was a snmp-server view,snmp-server group and snmp-server user.I used the same template on the 3945 w...
Hi, I did report to Cisco and they were going to look into possible bug fix, not seen reply yet.The workaround I used was to manually set the snmp engine id using a MAC add from one of the interfaces.Issue: Same snmp engineID local appears on multip...
The engine id on all 3 routers is :Local SNMP engineID: 800000090300000000000000Remote Engine ID IP-addr PortImages are c3900-universalk9-mz.SPA.151-4.M2.binc2951-universalk9-mz.SPA.151-4.M1.binI've found embedded-service-engine interface...
I've had same issue recently on 1801, only way around was to put both IOS (old & new) on router issue boot system flash command "new IOS" to conf, then delete old IOS file from flash and reload.
