Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello every one,I actually starting to work on a cisco project. I'm a beginner on networking and cisco technologie.For my project we use a router 2921.We got two network:- Network A: 192.198.0.X / 255.255.255.0 / Gateway 192.198.0.1- Network B: 162.1...
hi, we recently acquire a cisco 2921/K9 router to interface 2 networksNetwork 1 : 169.254.XXX.XXX/16 on GigabitEthernet0/0 interfaceNetwork 2 : 192.168.1.XXX/24 on GigabitEthernet0/1 interfaceon the network 1 side there is a multicast source (169.25...
I remove physical port IP and i put bridge-group xI put IP on BVI interface.After check that every thing is correct, i do:copy running-config startup-configAnd I think yes the rest of the IRB config is load, 'no shutdown' and 'mask' was presentes.
I tried the IRB solution, It's a good one.It's working and doing the job. So I put it in the startup-config but when i turn off and restart the router, IRB config doesn't work.BVI lost is IP config, one interface take the IP config and of course the ...
Hi,Yes it's what we try to do!The main problem is, we can't put le PC on the switch A, because the switch A is at 80 meters from the router. We need it near the router. We cannot add an extrat switch near the routeur for connect the router before the...
